tutorials:mapping:first_room
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| tutorials:mapping:first_room [2026/07/14 20:05] – fe80:de32:249f:bff1:c679:f02c:c416:ed28 | tutorials:mapping:first_room [2026/07/14 20:09] (current) – fe80:de32:249f:bff1:c679:f02c:c416:ed28 | ||
|---|---|---|---|
| Line 63: | Line 63: | ||
| Textures go on lines, Flats are textures on the floor/ | Textures go on lines, Flats are textures on the floor/ | ||
| - | There are 3 places you can place a texture on lines: Upper, Lower, and Middle. Upper is the wall that's created when you lower a ceiling down. Lower is the wall created when you raise a floor. Middle is the space between (for transparent textures), or a wall that has no sector behind it. You can change the textures either by going into the Lines mode (L, or click the button) and right-clicking them, or by going into the 3D mode (Q) and right clicking the highlighted line there. You may notice that if you place a middle texture that you can walk through it. Don't worry about that, or skip to the Linedef Properties section below. | + | There are 3 places you can place a texture on lines: Upper, Lower, and Middle. Upper is the wall that's created when you lower a ceiling down. Lower is the wall created when you raise a floor. Middle is the space between (for transparent textures), or a wall that has no sector behind it. You can change the textures either by going into the Lines mode (L, or click the button) and right-clicking them, or by going into the 3D mode (Q) and right clicking the highlighted line there. You may notice that if you place a middle texture |
| ;#; | ;#; | ||
tutorials/mapping/first_room.1784059515.txt.gz · Last modified: 2026/07/14 20:05 by fe80:de32:249f:bff1:c679:f02c:c416:ed28
